AV100 Auger Valve and Controller

Features

  • In-Built positive shut-off mechanism ensuring drool-free dispensing.
  • Ability to remove the wetted part and be stored safely in a fridge to be re-used hence reducing wastage of material.
  • Consists of various leadscrew sizes for precise dispensing volumes.
  • It does not require high material feed pressure thus reducing built-up pressure.
  • Easy to install, clean and requires less maintenance.
  • Compatible for most types of material.
  • Easy to use and maintain.
  • Very intuitive controller interface.

AV100 is designed with a positive shut off that eliminates drooling. Tailing and drooling are the most common problem in dispensing application; these problems can be eliminated with AV100’s build in positive shut off feature. More importantly, this new feature allows the valve to dispense fluids with viscosity as low as 5000 cps. Similar to the AV200, the AV100 is also driven by a DC servo motor which provides accurate and precision dispensing results.

The AV100 auger valve is specifically designed for precision, accuracy, and repeatability. The AV100 can be seamlessly integrated with TechnoDigm's signature dispensing robots, resulting in a holistic dispensing system capable of fulfilling the requirements of applications such as gasketing, dam and fill, as well as component encapsulation.

Like all TechnoDigm products, the AV100 is designed with maintainability in mind. The wetted component of the AV100 can be dismantled easily and quickly, without any tools. This allows the production to save and keep the material for the next operation.

Coupled with the AVC1000 controller, users have fine control over dispensing parameters such as the auger speed, dispensing time, and material pressure. This ensures user will achieve accurate & precise dispensing results at all times. With its internal memory, user can save up to 10 program recipe that can be easily load and recall for respective applications.

Operating type DC Servomotor On / Off
Motor output power 100 W, DC24V
Driving torque Max 0.83 Nm
Material inlet pressure 0.1 bar to 2 bar
Motor rotational speed 1 to 400 rpm
Dispense time interval 0.1 to 9999 second
Viscosity range Low (5k cps) to High (500k cps)
Material inlet Female Luer Lock Connector (standard)
Ø6 or Ø8 Compression Fittings (optional)
1/4” NPT Male Port (optional)
Material Outlet Lock nut for Standard Needle
Operating temperature 20 ~ 40°C
Controller Technodigm AVC1000
Controller Memory 10 Programs
Weight 1260g
Type of feed screw 8 pitch with 1.5mm depth of cut
Maximum dispense rate Maximum dispense rate for high viscous material (500k cps) is 50mg/sec (material dpendent)

 

Type of material used
Auger chamber Hardened Stainless Steel
Leadscrew Hardened Stainless Steel
Seal Urethane Compound
Oring Viton / FKM / Fluorocarbon